next up previous contents
Next: Graphics and Splines Up: SeqROI Tool Previous: SeqROI Tool   Contents

Introduction

The purpose of this tool is to allow the user to mark around 3D structures (using closed 2D splines), to display these in 3D, and allow them to be saved and loaded, recording the volumes of the structures marked (see Tina memo 2000-010). These regions can then be applied to other processing in order to summarise parametric measurements within regions (or simply to measure volumes). The software is currently restricted to be able to manipulate up to 6 separate volumes.

In order for the tool to work properly the sequence of images you are considering needs to be loaded and shown in a SequenceTv.



root 2017-09-24