The Mono Tool handles a single Tv display device, called mono. The Stereo Tool has three Tv's associated with it, called left, right (image display) and threed (3D tina primatives recovered from stereo). The Sequence Tool has a single Tv which shows one image from a set of images at any time.
The available display facilities are listed below, you can have any, all or none of them, initially only the image is set to be shown. To change the displayed image press the redraw and repaint buttons on the associated Tv tool.
Mono
image Display current mono image (the one input by the mono_tool).
edges Display current mono edges. These are drawn as pixels (a box
around the perimeter of the pixel) in the location of the image
array where the edge is located (stored).
corner Display current corners (hard to see at present).
strings Display current mono linked edge strings. These are drawn
between the current sub-pixel edge locations (in ``salmon'').
geom Display current mono 2D geometry (conics in ``yellow''and
poly lines in ``baby blue'' ).
Left and Right
image Display current left and right images.
edges Display current left and right edges.
corner Display current corners.
str Display the current left and right linked edge strings.
geom Display the current left and right 2D geometry.
other Allows other modules to register alternative image features.
Threed
geom Displays 3D geometry.
ground Displays elected ground plane (if available).
other Allows other modules to register alternative 3D features.
At any stage the left and right images can be used to generate a red green anaglyph which will be displayed in the Current Tv using the selected colour-map.